Partsam3PCS Amber Cab Roof Running Marker Lights +5xT10 5050 Amber LEDs Compatible with Silverado/Sierra 1500 1500HD 2500 2500HD 3500 2002 2003 2004 2005 2006 2007 Pickup Trucks

Poor Quality no installation instructions. Not very bright for LEDS

The lights was easy to install and looked good. Had to turn the bulbs around in the center as suggested in the instructions. The sockets kept falling out of the housing as I worked to place the bulb in. A few hot days and a rain day I noticed that the passage side bulb assemble housing was warped at the bottom of the housing and water had collected inside. The middle housing for the 3 lights was also warped and only 1 light was working. I removed the cover on the middle light assembly and swopped the bulbs around. The bulb housings kept falling out. Securing the sockets into the housing and again removing and replacing the bulbs all three light lit up. Then I noticed the problem. the contacts that supply energy to the lights was barely contacting the rails that supplied the current. Adjusting the rails solved the problem. Vibration made the lights flicker or not function. A better way to assure a good contact would be to solder the two together. Back to the passages side assembly I removed the housing. Wiped the lends removing the water and the lower housing. I used a clear silicone around the housing in and out. I silicone the lens to the housing , placed silicone in the holes for the screws and placed the screws in and tightened them down adding silicone over the screws. A few days go by and then it rains. The lens had water running down with in the lens. Water in the housing. I'm not happy with the quality of this product.

HelloI bought this roof light setup andworks very well.This is my second one after installlater on a bulb goes out when you remove light the sun destroys the rubber around the plastic lens so after reinstalling it always leaks with rain. Only repair is to replace it again with a brand new one.Sealers won’t work.

They were a great inexpensive replacement that lasted a year-and-a-half. At a year-and-a-half-old, they look as faded as the oe, also the lights are starting to crack and leak. Original equipment lasted for 15 years, these had a good year before needing to be replaced again.

Might be the only option. Bought these for a 98 f150 xlScrewing down the fixture there is a rubber o ring, it twists from under the screw head leaving it not water tight. They sent screws to install along with a ground wire. How do you connect the ground wire to a stainless steel screw? Should have been tiny nuts and bolts. Put the lights in and only the driver side worked. Passenger side still not working and the center light has two bulbs not working. Plastic fixture material is cheap and not accurate for simply just putting together. Lots of uncleaned edges where the bulbs go. Two contacts pushed through the rubber grommet while trying to install the bulb. IDK i think i might return these even after all ive gone through to install. Not the easiest and very cheap and generic.